3PHASE-40K Networkable Digital Power Amplifiers


Main Features

- Worldwide highest output power level and greatest extra headroom
- Three or Single* phase very wide range of AC line operation with APFC
- Easy interfacing to the 3X 400V** distribution without Neutral connection
- Reduced current draw and line cabling cost, saves lots of copper
- No more line-to-line balance problems, moreover the amp helps to keep
  the best symmetry betweenphase conductors in 3 Phase operation mode
- Fault-tolerant to power line anomalies, still operational with 2 phases
- Network control over standard ETHERNET, Open Source drivers
- Optional DSP module with 24bit/192KHz HiDefinition sample rate
- Full soft switching implemented with very high power conversion efficiency
- Supercompact size and small weight in rugged 1RU steel case
- Easily readable large format display and accurate output level metering



 Downloads





Technical Specifications

Parameter PKN 3PHASE-40K PKN 3PHASE-20K
Channel number 4 input/ 4 output 2 input/ 2 output
Output Power 8 Ohms 4 x 4000W 2 x 4000W
Output Power 4 Ohms 4 x 7500W 2 x 7500W
Output Power 2.6 Ohms 4 x 10000W 2 x 10000W
Bridged Output Power 8 Ohms 2 x 8000W 1 x 8000W
Bridged Output Power 4 Ohms 2 x 15000W 1 x 15000W
Bridged Output Power 2.6 Ohms 2 x 20000W 1 x 20000W
Peak Output Voltage per Channel 256V (181Vrms)
Peak Output Current per Channel 130A
Power Supply
Dual, Two independent High Frequency Resonant Switching with active Power Factor Correction
Typical Power Factor
>0.92 above 2000W
AC Power input in Three Phase mode
3x 400V (25A**) no Neutral connection needed
AC Power input in Single Phase mode 230V (63A**)
Operational AC Voltage range in Three Phase mode
3X 208V- 3X480V 45...65Hz Still operational in case of single phase loss
Operational AC Voltage range in Single Phase mode 90V- 275V** 45...65Hz 400Vac proof in single-phase mode
Maximum AC line current draw in Three Phase mode
3X 32A (Separated AC Power limiter for AB and CD Channels)
3 x 16A
Maximum AC line current draw in Single Phase mode 80A 40A
Inrush current limiting Yes, very soft turn-on
Minimum Operational AC input
65V (Single Phase mode)
AC Overvoltage Proof
1.5 KV in Three Phase mode, 0.75 KV in Single Phase mode
Signal to Noise ratio (with “A-weighed” filter) 112dB
Frequency response (+/- 0,05dB)
20Hz – 30KHz
Frequency response (+/- 3dB
5Hz - 60Khz (High Frequency filter off)
Damping factor (20-100Hz, 8R****) >12000
Damping factor (1KHz, 8R****)
>6500
THD + IMD (20Hz - 20kHz full power)
0.15% max (typical <0.05%)
Output Slew Rate
100V/us (Input and HF filters bypassed)
Crosstalk (A <-> B), (C <-> D)
>75dB
Crosstalk (AB <-> CD)
>106dB
-
Output protections CCM (0 Ohm STABLE), Overload, Short circuit, HF, unmatched loads, DC fault, lost connection, Programmable limiters
Input sensitivity (analog inputs) 0.775Vrms or 2Vrms (configurable from the menu)
Input impedance 10K+10K, Balanced
Output connectors 4X NEUTRIK NLT4M* 2X NEUTRIK NLT4M*
Input connectors 4X NEUTRIK XLR 2X NEUTRIK XLR
Networking Standard Ethernet
Built-in DSP Optional
Size 1RU, 455mm depth 1RU, 285mm depth
Limiter
Output Voltage (1V/step), Sustained Output Power Limiter (10W/step)
Latency from the analog inputs
1 ms
Weight 13,7 Kgs 8 Kgs
Operational temperature range 0C - +45C
Built-in DSP Optional
Cooling Forced air cooling with hidden high-performance FANS , Front to rear airflow


** There is a possibility of multiple line-current limiting methods from the menu booth in three and single phase mode
*** Maximum performance is around 3X400V or 230V operation, bellow 208V the sustained output power performance drops, please see the   deration graphs(1).
**** Measured directly on the output points Preliminary Specificiations are subject to change without prior notice







     All content (C) 2001-2012 PKN Audio Ltd., all right reserved. All our products are made in the EU
     Product specifications might change without prior notice